Mahindra 3535, Operator'S Manual

Page: 89 / 108

88
35 Series-HST, Model - 3535, 4035, 4535 & 5035
Specifications
MAHINDRA – 4535 HST
ENGINE
Four Stroke, Naturally Aspirated, Direct Injection,
Water Cooled Diesel Engine
Model : CE 45
No. of Cylinders : 4
Displacement : 153.7 cubic inch.
Bore : 3.5 in.
Stroke : 4 in.
Compression Ratio : 19.4:1
Max. Engine Hp* : 45 max. as per DIN-70020
(Manufacturing Rating)
Rated Speed : 2800 rpm
High Idle r.p.m. : 2975 ± 50
Low Idle r.p.m. : 1000 ± 50
Fuel Injection Pump : Rotary FIP with I-KSB
Unit MICO (BOSCH INDIA)
Cylinder Sleeve : Wet-Replaceable
Air Cleaner : Dry type with safety
cartridge & automatic
dust unloading
Exhaust Muffler : Under Hood, Horizontal,
Downswept
Firing Order : 1 - 3 - 4 - 2
Accelerator : Hand & Foot Accelerator
Injector Opening Pressure : 3510 - 3742 PSI
ELECTRICAL STARTING AND LIGHTING
Battery Capacity : 12 volt, 96 amp
Starter : Solenoid engaged.
Key start with interlock
safety neutral switch.
Alternator : 12 volt, 45 amp
Instrument Cluster : Water Temperature Gauge,
Fuel Gauge, Voltmeter,
Electronic RPM Meter +
Hour Meter, Battery
Charging Indicator.
Tell-tales : LH & RH Turn
Indicators, High Beam
Indicator, Parking Brake
Indicator, 4WD Indicator.
Lighting : Head Lights, Direction Indicator,
Front and Rear Position,
Brake Lamp, Plow Lamp.
Heater Plug System for : Main Components :
Cold Starting 1. Heater Plug
2. Timer Relay
TRANSMISSION
Type : HST, with Safety Neutral Switch
in Forward / Reverse
: Range Section Full Constantmesh
No. of gears : 3 Range HST
STEERING : Hydrostatic with Tiltable Column
POWER TAKE OFF
Type : Rear Independent PTO shaft
P.T.O. HP* (metric) : 36.5 max.
P.T.O. RPM : 540 (6 Splines)
(Independent P.T.O.)
@ 2404 Engine RPM
PTO System : Main Components :
1. PTO Solenoid
2. PTO Relay
3. PTO Flasher
Specs : Nominal Voltage : 12 volt
Current Consumption : 1 amp
BRAKES
Oil Immersed Wet Brake, Foot operated, independent
with provision of interlock for simultaneous operation.
A hand brake lever is provided for parking.
Number of lining : 4 each side
HYDRAULIC SYSTEM
Open Center, Full Live Hydraulics with Position and Draft
Controls.
Working pressure : 2900-2972 PSI
Max. lifting force at
lower link hitch point
: 3090 lbs.
Pump output : 11 Gallons/min.
3 Point linkage : Category
I
ball joints with
Telescopic Lower Link.
AUXILIARY VALVE
1. Single Spool - Standard
2. Two Spool - Optional, available as kit with Dealer
FRONT AXLE
Mechanical Front Wheel Drive (MFWD) with Bevel Gear
Final Reduction.