14-14
© Copyright Mahindra & Mahindra Ltd.012016
14.5.11 Changing the Wiper Blade
1.
Lift the arm and position the wiper blade at right angles to the
wiper arm
2.
Press the retaining clip in the opposite direction, disengage the
wiper blade and pull it off the arm
To prevent damage to the windshield, don’t let the wiper arm slap
down on to it.
3.
Hold the end of the rubber and pull until the tabs are free of
the metal support
4.
Carefully insert the new blade rubber. Then install the blade
assembly in the reverse order of removal
14.5.12 Fuel Filter Bleeding/Priming
W12N12
When the fuel level in the fuel tank falls very low, air may enter the
fuel lines which leads to the engine not starting or abrupt switching
OFF.
The air has to be removed from the fuel pump by bleeding and
priming the fuel pump. The fuel pump is located next to the power
steering fluid reservoir in the engine bay. Unscrew the drain nut
below the pump by 1– 2 turns and observe fuel flow. If there is no
fuel flow or intermittent flow, close the drain nut and pump the fuel
filter repeatedly using your palm. Again check for fuel flow by
unscrewing the drain nut. Once the flow is normal, tighten the drain
nut and try starting the engine. If it fails, drain/pump few more
times and retry. If the engine still does not start, contact your
nearest Authorized Mahindra Dealer for assistance.
MAINTENANCE