MAHA DUO CM Series, Operating Instructions Manual

Page: 21 / 45

21
BA082901-en
Make sure to center the vehicle on the lift. Eccentric positioning may result in faulty
measurement.
5.6 Lowering

1 To lower the lift press the LIFT DOWN button until the desired height is reached.

Lift briefly raises to disengage the latches from the mechanical locks.

Lift stops once button is released or lower limit stop is reached. The lift always stops
shortly before bottom position.
2 To lower the lift completely, release the LIFT DOWN button and push it again.

During lowering of lift an audible signal sounds.
3 Release parking brake, remove chocks and drive the vehicle off the lift.

When completely lowering the lift, be sure to push the LIFT DOWN button until the
LED of the LOCK button lights up.

The lift can be fully lowered only when the axle lift is in its home position.
5.7 Wheel-Free Jack (Optional)
Raising

Vehicle must be centered over the wheel-free jack.
1 Lift the extensions using the handles and position them under the vehicle lift points.
2 If required, use additional spacer blocks under the vehicle.
3 Raise the vehicle briefly using button <WFJ UP> and check for secure contact of the
extensions at the vehicle manufacturers' recommended lift points. Then raise the
vehicle to the desired height.

Raising motion is stopped when button is released or upper limit stop is reached.
Lowering
1 Use button <WFJ DOWN> to lower the wheel-free jack.

Lowering motion is stopped when button is released or lower limit stop is reached.
An audible warning signal sounds while the jack is lowering.