Magtek EXPRESSCARD 1000, Hardware Service Manual

Page: 72 / 194

Section 4: Removal and Replacement
65
Move the sled on the XY assembly to the center of the assembly track.
4. Remove the six Allen screws (1/8 Allen, 6” long will be needed) that secure the XY
assembly to the top deck and the Phillips screw that secures the ground wire to the top
deck.
5. Grasp the XY assembly from the opposing black ends and lift away from the top deck.
6. After the replacement process is completed verify that the print/emboss alignment is in
the proper location by printing a sample test card.
Note: when replacing the XY assembly make sure that the alignment bosses are placed
in the corresponding holes on the top deck; failure to do this will case alignment issues
and the assembly will not work properly.