4 - Installation
DynaFlex II| Product Family | Installation and Operation Manual
Page 23 of 78 (D998200554-10)
If your solution design involves custom mounting brackets, contact your MagTek representative to
request design advice and assistance from MagTek’s Engineering team.
4.4.3
How to Mount DynaFlex II Kiosk Models
This document describes how to use DynaFlex II Kiosk models securely. Using the device
in any way other than the approved methods described in this document invalidates the
PCI PTS approval of the device.
Not following the guidelines in this section could damage the device, render it inoperable,
and/or violate the conditions of the warranty.
This section provides information and guidelines for designing the mechanical aspects of a solution that
incorporates DynaFlex II Kiosk models. MagTek strongly recommends vetting and testing solution
designs before finalizing and deploying them to make sure the design meets all requirements (e.g.,
functional, legal, security, certification, safety, and so on).
When designing the mechanical portions of a solution that incorporates DynaFlex II Kiosk models,
consider the following:
•
Components for an overall introduction to the device’s
physical features and what they are called.
•
Appendix A Technical Specifications
•
Review the information below about overall device dimensions and mounting hole locations and use.
•
Determine device orientation. The device supports all four orientations.
•
Review any additional requirements from other agencies, such as PCI and EMV solution certification
requirements, safety ordinances, and so on, which may introduce additional constraints to the design.
Overall dimensions of the device are shown in
. On request, MagTek can
provide a 3D model of the device’s envelope to assist with the mechanical portion of solution design.
MagTek strongly recommends building and testing prototypes with actual devices before finalizing the
solution design.
