MAGSTIM NEUROSIGN V4, Service Manual, Page: 35 / 50

The Magstim Company Ltd.©
35
NOP20-EN-03
5.3 Software Upgrade
Retaining
Screw
SD card
Housing
can now be removed.
• Using a suitable SD card reader, connect the SD card to a PC/laptop.
• Install the software upgrade onto the SD card.
• Return the SD card into its housing at the rear of the touch screen DCU. A click
will be heard when the SD card is in place.
!Note: The SD card can only be inserted in one orientation. Do not apply force or
damage may occur.
• Replace the rear panel and secure with the retaining screw.
• Connect the AC mains power lead to the power input socket ( 19 , page 13).
• Set the power switch to ON (I) ( 20 , page 13).
Note : If language selection flags are displayed on start-up, the system configuration
must be completed. Refer to the user manual, "4.1 System Configuration" for more
information.
• On the home screen, press
• Press
• Verify software version displayed corresponds with the software upgrade version.
a. Touch screen DCU
Note:
Before removing the retaining screws
ensure that the nerve monitor is switched off and
disconnected from the AC mains supply.
Note: For information on how to obtain software
please contact the Service department (page
ii).
• Remove the retaining screw from the rear
panel of the touch screen DCU ( right ).
• Remove rear panel by sliding downwards
(indicated by an arrow).
• Gently push the SD card in to release the SD
card from its housing ( right ). The SD card