MAGSTIM NEUROSIGN V4, Service Manual, Page: 28 / 50

The Magstim Company Ltd.©
28
NOP20-EN-03
iii. Touch screen DCU and SD card replacement
Upon return of the touch screen DCU;
• Re-attach the touch screen DCU to the upper spine using the original screws
( below ).
Retaining
Screw
SD card
Housing
• Remove the retaining screw from the rear panel
of the touch screen DCU (
right
).
• Remove rear panel by sliding downwards
(indicated by an arrow).
• Return the SD card into its housing ( right ). A click
will be heard when the SD card is in place.
!Note: The SD card can only be inserted in one
orientation. Do not apply force or damage may occur.
• Replace the rear panel and secure with the
retaining screw.
• Connect the UI cable to the touch screen DCU and the mains unit, (
14
(a)
14
(b) , page 13).
• Connect the AC mains power lead to the power input socket ( 19 , page 13).
• Set the power switch to ON (I) ( 20 , page 13).
• Verify the system powers up correctly and that the patient data is restored.
Note
: If language selection flags are displayed on start-up, the system configuration
must be completed. Refer to the user manual, "4.1 System Configuration" for more
information.
Bolt