Model OE-10
Installation, Operation and Maintenance
Page
3
Rev. 4/20/07
V
ERTICAL
C
LEARANCE
Check the height of the area where the lift is to
be installed. Clearance should be calculated
based on the full raised height of the lift.
Failure by purchaser to
provide adequate
clearance could result in
t performance, property
damage, or personal injury.
fade
WARNING
unsatisfactory lif
F
OORING
ou have the proper concrete floor to
for concrete are 4
ing inspectors and/or
aser to
result in unsatis
E
n for single
S
read
UAL BEFORE
HIS
TENANCE AND
R SAFE
RATE A DAMAGED LIFT
d, or damaged d
tempt to raise a
L
Be certain y
properly handle the loaded lift. Floor should be in
generally good condition with no large cracks,
spalling or deterioration.
Minimum requirements
inches minimum depth, with steel
reinforcement, 3500 psi, cured for 28 days per
local commercial practice
. Floor should be
level within 3/8 inch over the installation area. No
anchors should be installed within 8 inches of any
crack, edge, or expansion joint. If these
conditions cannot be met, a pad may be poured
to accommodate the lift.
Check with local build
permits office for any special instructions or
approvals required for your installation.
Failure by purch
provide the recommended
mounting surface could
factory lift performance,
property damage, or personal injury.
LECTRICAL
R
EQUIREMENTS
For lift installation and operatio
phase units, it is necessary to have a
dedicated circuit with a double pole 25 amp
circuit breaker or time delay fuse.
AFETY
N
OTICES AND
D
ECALS
For your safety, and the safety of others,
and understand all of the safety notices and
decals included here.
R
EAD ENTIRE MAN
ASSEMBLING
,
INSTALLING
,
OPERATING
,
OR SERVICING T
EQUIPMENT
.
P
ROPER MAIN
INSPECTION IS NECESSARY FO
OPERATION
.
DO NOT
OPE
.
Safety decals similar to those shown here are
found on a properly installed lift. Be sure that all
safety decals have been correctly installed on the
Power Unit reservoir. Verify that all authorized
operators know the location of these decals and
fully understand their meaning. Replace worn,
ecals promptly.
Do not at
WARNING
vehicle on the lift until the
lift has been correctly
installed and adjusted as described in this
manual.
WARNING
A2151_MAGNUM.doc
