MIG200L PRO DUAL PULSE
3
• Implanted Medical Device wearers should consult their doctor and the device manufacturer
before going near any electric welding, cutting or heating operation.
Noise can damage hearing. Noise from some processes or equipment can damage
hearing.
• Wear approved ear protection if noise level is high.
Hot parts. Items being welded/cut generate and hold high heat and can cause severe burns.
Do not touch hot parts with bare hands. Allow a cooling period before working on the
welding/cutting gun. Use insulated welding gloves
and clothing to handle hot parts and prevent burns.
CAUTION
1. Working Environment.
i. The environment in which this welding/cutting equipment is installed must be free of grinding dust,
corrosive chemicals, flammable gas or
materials etc, and at no more than maximum of 80% humidity.
ii. When using the machine outdoors protect the machine from direct sun light, rain water and snow etc; the
temperature of working environment
should be maintained within -10°C to +40°C.
iii. Keep this equipment 30cm distant from the wall.
iv. Ensure the working environment is well ventilated.
2. Safety Tips.
i. Ventilation
This equipment is small-sized, compact in structure, and of excellent performance in amperage output. The
fan is used to dissipate heat generated by this equipment during the welding/cutting operation. Important:
Maintain good ventilation of the louvres of this equipment. The minimum distance between this equipment
and any other objects in or near the working area should be 30 cm. Good ventilation is of critical importance
for the normal performance and service life of this equipment.
ii. Thermal Overload protection.
Should the machine be used to an excessive level, or in high temperature environment, poorly ventilated area
or if the fan malfunctions the
Thermal Overload Switch will be activated and the machine will cease to operate. Under this circumstance,
leave the machine switched on to
keep the built-in fan working to bring down the temperature inside the equipment. The machine will be ready
for use again when the internal
temperature reaches safe level.
iii. Over-Voltage Supply
Regarding the power supply voltage range of the machine, please refer to “Main parameter” table. This
equipment is of automatic voltage
compensation, which enables the maintaining of the voltage range within the given range. In case that the
voltage of input power supply
amperage exceeds the stipulated value, it is possible to cause damage to the components of this equipment.
Please ensure your primary
power supply is correct.
