2
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-76100 & MI-76150 DRILL PRESSES
•
Before you assemble your drill press, review the parts breakdown and keep it ready for reference.
•
Start by removing the parts from the packaging.
•
Carefully check the packaging for small pieces before you continue.
•
Lay out the parts on a large, clear and unobstructed area and ensure that all parts are accounted for.
•
If you have any questions or require further information, please contact the KMS Tools Service Department at 604.395.4134
or email
ASSEMBLING THE DRILL PRESS
1. Bolt the
BASE FLANGE (4)
and
COLUMN (19) t
o the
BASE (1).
2. Carefully remove the
RACK COLLAR (21)
from the
COLUMN (19)
. Apply even pressure and gently slide the
COLLAR
. Using
too much force can cause the
COLLAR
to bind. If it is tight, try gently tapping the
COLLAR
.
3. Ensure that the
WORM GEAR (10)
and
HELICAL GEAR (9)
are installed in the
TABLE BRACKET (7)
and have not fallen out
during unpacking.
4. Place the
RACK (18)
into the
TABLE BRACKET (7)
. The tapered end of the
RACK
faces upward and the square end faces
downward.
5. Lower the
RACK (18)
and the
TABLE BRACKET (7)
onto the
COLUMN (19)
. Take care to hold the two pieces together. This
may require two people.
6. Fit the bottom lip of the
RACK (18)
in the friction ring on the
BASE FLANGE (4)
. Secure the top of the rack by installing the
RACK COLLAR (21)
. Tighten the
SET SCREW (20)
in the
RACK COLLAR (21)
. Take care not to over tighten.
7. Slide the
CRANK SLEEVE HANDLE (6)
on the
WORM GEAR (10)
and secure it with the
SET SCREW (5)
.
8. Lower the
HEAD (26)
to the
COLUMN (19)
and secure the
HEAD (26)
by tightening two
SET SCREWS (26-1)
. This may
require two people.
9. Secure the
TABLE (17)
onto the
TABLE ARM (12)
.
10. Attach a
HANDLE KNOB (23)
to each of the three
FEED HANDLES (22)
. Then secure the
HANDLES (22)
to the
PINION
SHAFT (24)
.
11. Thread a light bulb (maximum 40 watts) into the
LAMP HOLDER (32)
. (Light bulb sold separately.)
12. Remove the protective coating from all surfaces using a rag dipped in environmentally safe degreaser
INSTALLING THE CHUCK
1. Degrease all pieces. Slide the
ARBOR (53)
into the
SPINDLE (51)
, flat end up.
2. Slide the
CHUCK (54)
over the tapered end of the
ARBOR (53)
and, using a wooden mallet, give the
CHUCK
a good tap. The
taper is designed to hold the
CHUCK
securely in place.
