Shutdown and Cleaning
312001P
17
Shutdown and Cleaning
Pail Flushing
•
For short term shutdown periods (overnight to
two days) refer to Short Term Storage, page 22.
•
For flushing after spraying oil-based coatings,
use compatible oil-based flushing fluid or min-
eral spirits. Read Priming and Flushing Storage
Fluid, page 11.
•
For flushing after spraying water-based coat-
ings, use water. Read Priming and Flushing
Storage Fluid, page 11 or Power Flush, page
19.
1. Relieve pressure, page 10.
2. Remove tip and guard assembly from gun and
place in flushing fluid.
3. Lift suction tube and prime tube from paint pail.
Let them drain into paint pail for a while.
4. Separate prime tube (smaller)
from suction tube (larger).
5. Place empty waste and
water or solvent pails
side by side.
6. Place prime tube in waste
pail.
7. Submerge suction tube in
water or flushing solvent.
8. Turn pressure control knob to
the Prime/Clean setting.
9. Turn power switch ON.
10. Flush until approximately 1/3 of the flushing
fluid is emptied from the pail.
11. Turn power switch OFF.
ti2039a
ti9726a
ti9652a
ti9651a
ti9344a
ti5580a
ti2018a
Summary of Contents for 261815
Page 83: ...Notes 312667H 51 Notes ...
