Magnum Winchester Elite WIN-ACI, Owner'S Manual

Page: 34 / 49

34
CLEANING INSTRUCTIONS FOR THE WINCHESTER INSERT
WARNING: DISCONNECT THE POWER CORD BEFORE CLEANING OR SERVICING THIS UNIT.
THE STOVE MUST BE TURNED OFF COOLED BEFORE USING THE RAKE HANDLE.
II. HEAT EXCHANGER:
This stove is designed with a built-in heat exchange tube rake. The ash rake handle is located on
the front of the stove and is moved backwards and forwards several times to remove the buildup of ash.
After cleaning, push the rake handle in until it stops.
III. COMBUSTION BLOWER:
Over the course of the heating season dust and ash may collect on the blades of the combustion
blower. Periodically they should be inspected and vacuumed clean. The combustion blower is accessed by
removing the inspection caps or the exhaust manifold cover (See figure below). Never operate the stove
without the inspection cap or manifold cover in place.
IV. VENT EXHAUST BOX:
The vent exhaust box is accessed by removing the inspection cap (See figure below). Periodically
it should be inspected and vacuumed clean.
The convection (room air fan) blower will accumulate dust, pet hair, etc. on the blades during the heating
season. This must be vacuumed and clean as needed. If you have pets, the convection blower will need to
be cleaned regularly as the pet hair will clog up the blades and motor windings and cause premature wear,
overheating and failure of the blower system.
Manual reset 225 deg.
Normally closed high temp
disc