Magnum Industrial MI-91520, Operating Manual

Page: 8 / 35

ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91520 DELUXE 14” BAND SAW
ATTACHING THE TABLE CONTINUED
4. Rotate the table 1/4 turn counterclockwise so
that the saw blade is now perpendicular to the
TABLE SLOT (F). See Figure 11.
5. Gently lower the table onto the bracket so
the LONG BOLTS (C) in the centre of the
trunnlons pass through the holes in the
TABLE-TILT BRACKET (G). See Figure 12.
6. Tread the two small LOCK KNOBS (H) onto the
LON! BOLTS (I) now protruding from the
underside of the tabletilt bracket and tighten
carefully. See Figure 13.
7. Attach the TABLE TILT SUPPORT BRACKET
(J) to the rear of the saw using the BIG LOCK
KNOB (K) with the two FLAT WASHERS (L)
already mounted on the frame. See Figure 14.
8. Make sure that the blade is centered in the
TABLE OPENING (M). If the blade is not
centered, slide the table back or forward until
the blade is centered in the table opening. Then
fully tighten the two LOCK KNOBS (H). See
Figure 15.
9. Reinstall the insert into the centre of the table,
with the opening in the SLOT (O) facing the
rear of the saw. See Figure 16.
10. Reinstall the table alignment pin into the
TABLE SLOT (P). See Figure 17.
11 12
13
14
15
16 17
WARNING!
Serious personal injury
could occur if you connect
the saw to the power
source before you have
completed the installation
and assembly steps!
FIGURES 11 and 12: TABLE INSTALLATION
FIGURE 13: TABLE INSTALLATION
FIGURES 14 and 15: TABLE INSTALLATION
FIGURES 16 and 17: TABLE INSTALLATION