PREPARATION
SWITCH THE HEADLIGHT TESTER ON with the on/off
button on the side.
Wait a few seconds for local control of the device and
loading of the process software.
-
OPTIONS MENU
See the section on service and maintenance.
-
APPLICATIONS MENU
Press the TOUCH button for the applications; the device
can perform two types of TEST:
-
OFFICIAL
-
FREE
The OFFICIAL test is enabled only when there is a
connection with the station PC, with communication in DIR
mode.
The FREE test is enabled if there is no connection with the
station PC.
SETTINGS
This menu requires the following data:
- type of vehicle being tested
2 headlights:
“automobiles”
1 headlight:
“motorcycles”
1 headlight, low beam only:
“motorbike”
- type of headlight
asymmetrical
symmetrical
- type of light
halogen
xenon
- headlight tilt
read at the top of the headlight the tilt indicated
by the manufacturer, e.g. 1.2%, set the value
using the + and - key.
- height of headlight from ground
set the value using the + and - key.
CAUTION!
Remember that the headlight tilt must in any case comply with the law in force, which establishes that for
low
beam headlights
at a height above ground of up to 80 cm the tilt must be at least 1%.
For low beam headlights higher than 80 cm the tilt must be at least 1.5%.
HEADLIGHT TEST
