Flex Mini System Instruction Manual
June 2015
Page 17 of 25
PB4
PB4
RX to TX Pairing:
Output data - receiver
Receiving data transmitter
(Press and hold PB1)
(Press and hold PB4)
Via the Decoder Board
JP1 Open Method (via the decoder board):
After entering the remote pairing mode, output receiver
data by pressing and holding PB1 located on the decoder board and receive data by pressing and
holding PB4 on the transmitter at the same time. The pairing is completed when the transmitter
Status LED turns to constant green while both buttons are still pressed down. Exit the transmitter
function setting mode by taking the batteries out of the transmitter and move the function dipswitch
back to the off position.
Output data - receiver
Receiving data transmitter
(Press and hold the Pairing button)
(Press and hold PB4)
Via the External Pairing Button
JP1 Open Method (via the external Pairing button):
After entering the remote pairing mode, output
receiver data by pressing and holding the Pairing button located on the receiver cover and receive
data by pressing and holding PB4 on the transmitter at the same time. The pairing is completed when
the transmitter Status LED turns to constant green while both buttons are still pressed down. Exit the
transmitter function setting mode by taking the batteries out of the transmitter and move the function
dipswitch back to the off position.
JP1 Short Method (does not require the decoder board or the external Pairing button):
After
entering the remote pairing mode, press PB1 on the transmitter and then press and hold PB3 for up to
5.0 seconds to activate receiver data output mode (Status LED green blinks). Then press and hold
PB4 on the transmitter until the Status LED turns to constant green (RX to TX pairing complete). Exit
the transmitter function setting mode by taking the batteries out of the transmitter and move the
function dip-switch back to the off position. Make sure the RX to TX pairing process is executed
within a distance of 10 meters from one another.
NOTE: When the transmitter keypad is set to type 1 while performing RX to TX remote pairing, the
receiver must be reset (turn off and back on) or the RX to TX remote pairing must be executed 5
minutes after receiver inactivity.
