Flex Mini System Instruction Manual
June 2015
Page 15 of 25
PB3
PB4
PB5
PB6
PB8 PB7
PB2
Type 1
PB1
PB3
PB4
PB5
PB6
PB8 PB7
PB2
ON
OFF
Type 2
PB3
PB4
PB5
PB6
PB8 PB7
START
Type 3
STOP
2.1.2 Keypad Type Settings
Enter the transmitter function setting mode by moving the function dip-switch located inside the
battery compartment to the on position. Reinsert the two batteries and press PB1 to power up the
transmitter. At this point the Status LED will display a series of red, green, and orange blinks showing
the current software version. Press and hold PB4 for up to 1.0 second to go into the keypad type
setting mode. At this point the Status LED will blink red, showing the current keypad type. A green
blink represents the tens (+10) and a red blink represents the units (+1). For example, two (2) red
blinks is keypad type 2.
Now select the new keypad type by pressing PB1 and PB2 on the transmitter. Press PB1 to
increment the units (+1) and PB2 to increment the tens (+10). For example, press PB1 two times for
keypad type 2 and three times for keypad type 3. The Status LED will display the newly selected
keypad type when finished. Exit transmitter function setting mode by taking out the batteries and
moving the function dip-switch back to off position.
NOTE: When selecting a new keypad type, make sure each button press does not exceed 3.0
seconds.
