Magnetek FLEX M Series, Manual

Page: 16 / 34

Enrange Flex M Pre-Engineered Modular Receiver Manual
October 2014
Page 13 of 31
4.1.2.3 Bank 2 Switch 3 – AUX 5/6 Output Configuration (Normally ON)
Definition: This feature sets the Aux 5/6 output relays to be either momentary or latched. When
set for momentary outputs, each output will remain on as long as the corresponding button on the
transmitter is held. When set for latched outputs, each output will turn on when the corresponding
button on the transmitter is pushed, and will turn off when the corresponding button on the
transmitter is pushed a second time.
The latching setting is not to be used for critical
latching functions, such as magnets. For critical latching functions, an external
mechanical latching relay should be used with the radio’s outputs configured as
momentary.
Programming: Turning bank 2 dip switch position 3 OFF (0) sets the Aux 5/6 outputs to latched.
Turning bank 2 dip switch position 3 ON (1) sets the Aux 5/6 outputs to momentary.
4.1.2.4 Bank 2 Switches 4 thru 8 – Radio Frequency channel select
These switches can be set per section 6.0 for the desired operational radio channel frequency for
the system.
4.2 FLEX M RELAY MODULE
The Flex M Relay module allows the control of high current power (up to 5A) for attached equipment
through eight relay outputs. Four relays have a common power input and four relays have individually
separate power inputs. There are typically 2 to 5 relay modules in Flex M systems where the relay
module number is set by the rotary switch located on the lower left corner of the board.
Flex Sys