Flex 8RS System Instruction Manual
December 2012
20 of 36
7
1
4
2 3
5 6
8
INT
EXT
1
2
3
5
6
8
4
7
4.2 RECEIVER UNIT
4.2.1 System Channel Settings
(Fig. 12)
Even though the Flex system is equipped with an automatic channel scanning receiver, the user
can also set the receiver channel manually. Please refer to page 32 on how the automatic
channel scanning receiver works.
Set the receiver channel by adjusting the channel dip-switch located on the receiver module
(refer to Fig. 12 above), only the first six (6) positions are used for channel programming (refer to
Fig. 13 below). The system channels table located on page 26 illustrates which dip-switch setting
corresponds to which channel. Once the receiver channel is altered make sure to change the
transmitter channel as well. The channel on both the transmitter and receiver must be identical in
order for the system to work. To change the transmitter channel please refer to page 13.
Example:
Top slot
→
“1”
Bottom slot
→
“0”
(Fig. 13)
The above dip-switch setting
“1 0 0 1 0 0”
corresponds to “channel 36” in the system channels
table on page 26.
