Flex 8RS System Instruction Manual
December 2012
32 of 36
1
2
7.1.2 Automatic Channel Scanning Operating Procedure
After changing the transmitter channel (refer to page 13), turn on the transmitter power and
rotate the power key switch to “Start” position and hold it there for up to 1 minute. Within this 1-
minute period the receiver will search (channel 01 ~ channel 62) and lock onto the newly
selected transmitter channel automatically. Please note that in order for the receiver to switch to
auto-scanning mode, prior to changing the transmitter channel, you must first deactivate the
receiver MAIN by shutting off the transmitter power or press down the emergency stop button.
Please refer to page 21 if you do not want the receiver to auto-scan all 62 channels.
Change Transmitter Channel
→
7.1.3 Changing Transmitter Batteries
Change the transmitter batteries by unscrewing the battery cover located on the backside of the
transmitter (refer to Fig. 19 below). During battery installation make sure that the blue ribbon is
centered between the two batteries. After changing the batteries also make sure that all screws
are tightened to avoid water, moisture, dirt, grease, or other liquid penetration.
(Fig. 19)
↓
