Flex 8EX A/B System Instruction Manual
June 2010
23 of 42
7
1
4
2 3
5 6
8
INT
EXT
1
2
3
5
6
8
4
7
B. RECEIVER
UNIT
1. System
Channel
Settings
(Fig. 12)
Even though the Flex system is equipped with an automatic channel scanning receiver, the
user can also set the receiver channel manually. Please refer to pages 27 and 38 on how the
automatic channel scanning receiver works.
Set the receiver channel by adjusting the channel dip-switch located on the receiver module
(refer to Fig. 12 above); only the first six (6) positions are used for channel programming (refer
to Fig. 13 below). The system channels table located on page 32 illustrates which dip-switch
setting corresponds to which channel. Once the receiver channel is altered make sure to
change the transmitter channel as well. The channel on both the transmitter and the receiver
must be identical in order for system to work. To change the transmitter channel please refer to
page 15.
Example:
Top slot
→
“1”
Bottom slot
→
“0”
(Fig. 13)
The above dip-switch setting
“1 0 0 1 0 0”
corresponds to “channel 36” in the system channels
table on page 32.