Flex 6EX System Instruction Manual
March 2016
Page 30 of 38
8
1. For best reception the location of the receiver should be visible to the operator at all time.
2. The location selected should not be exposed to high levels of electric noise. Mounting the receiver
next to an unshielded variable frequency drive may cause minor interference. Always locate the
receiver as far away from the variable frequency drive as possible.
3. Ensure the selected location has adequate space to accommodate the receiver (refer to Fig. 16
on page 29). If an external antenna is used, always locate the receiver where the antenna is free
from any obstacles from all directions to avoid the possibility of antenna damage.
4. When installing an external antenna you must connect the SMA jack located inside the receiver
and make sure to set the jumper to “EXT” position (refer to diagram below).
5. For better reception, make sure the receiver is in an upright position.
6. Drill one hole (8mm in diameter) on the control panel or location where the receiver is to be
installed (refer to below).
7. Make sure the bolt is tightened after installation.
8. For system wiring please refer to page 28.
