Flex 8EX EU System Instruction Manual
March 2012
17 of 37
7
1
4
2 3
5 6
8
INT
EXT
1
2
3
5
6
8
4
7
B. Receiver Unit
1. System Channel Settings
(Fig. 12)
Even though the Flex system is equipped with an automatic channel scanning receiver, the
user can also set the receiver channel manually. Please refer to page 32 on how the automatic
channel scanning receiver works.
Set the receiver channel by adjusting the channel dip-switch located on the receiver module
(refer to Fig. 12 above); only the first six (6) positions are used for channel programming (refer
to Fig. 13 below). The system channels table located on page 26 illustrates which dip-switch
setting corresponds to which channel. Once the receiver channel is altered make sure to
change the transmitter channel as well. The channel on both the transmitter and the receiver
must be identical in order for system to work. To change the transmitter channel please refer to
page 9.
Example:
Top slot
→
“1”
Bottom slot
→
“0”
(Fig. 13)
The above dip-switch setting
“1 0 0 1 0 0”
corresponds to “channel 36” in the system channels
table on page 26.
