Flex 8EX EU System Instruction Manual
March 2012
14 of 37
4. Channel Change via Push Buttons
Other than the CHANNEL dip-switch on the encoder board, the transmitter channel can also
be changed directly on the push buttons. Please refer to the instructions below on how to
change the transmitter channel via push buttons.
a.
Press and hold PB1, PB2 and PB3 and rotate the power key to START position at the
same time. A series of green and red blinks will appear on the Status LED showing the
current channel setting. A green blink represents the tens (+10) and a red blink
represents the units (+1).
Examples:
2 green blinks followed by 5 red blinks represents channel 25.
6 red blinks represents channel 06.
+
b.
Select a new channel by pressing PB1 and PB2 on the transmitter. Press PB1 to
increment the units (+1) and PB2 to increment the tens (+10).
Examples:
Pressing PB2 two times and then PB1 four times will give you channel
24.
Pressing PB1 nine times with give you channel 09.
c.
When finished, the newly selected channel will appear on the Status LED via a series of
green and red blinks again.
d.
Exit the channel programming by turning off the transmitter power.
e.
Make sure the receiver channel is set identical to the transmitter. Please refer to page 17
and page 32 on how to change the receiver channel.
f.
Please note that when the CHANNEL dip-switch inside the transmitter is changed, the
priority will revert back to the new channel set on the CHANNEL dip-switch.
g.
Please note that when channel is set beyond channel 62 via PB1 and PB2 (i.e. channel
63, 68, 88, etc…), the system will recognize it as channel 62.
