MAGNAWELD monoTIG 160ip, User Manual

Page: 22 / 56

22
www.magmaweld.com USER MANUAL | KULLANIM KILAVUZU
monoTIG 160ip
EN
When the torch trigger is pushed, main current starts immediately and goes on as long as the torch trigger is
kept pushed. Welding goes on during spot welding time. After spot welding time is over, current stops
immediately.
For using welding modes (2 Stroke - 4 Stroke - Spot Welding) in Flat DC mode, select Flat DC mode by button, its
led will be on. In this mode, only main current is used and it is simply adjusted by the multifunctional pot. For
using welding modes (2 Stroke - 4 Stroke - Spot Welding) in Pulse DC mode, select Pulse DC mode by button,
its led will be on. In this case, main current, base current and the Pulse frequency should be adjusted by the
multifunction pot. welding current changes between main current and base current in the adjusted Pulse
frequency.
Spot TIG Trigger
DC / Pulse DC
4 Stroke TIG Trigger
Push the welding mode selection button until the MMA led lights. In this mode, only the main current led lights
and welding current can be adjusted by the main knob. All other functions are inactive.
3.3.3 MMA Welding Process
Operation