13
Each specialty feature listed operates in the same manner regardless of the alarm model. Test each feature
by following the procedures enclosed to insure proper operation.
Remote Panic:
1. Press and hold the arm/disarm (for regular transmitters) or panic button (for code hopping
transmitter) down for approximately 3 seconds.
2. The alarm will begin to sound and the parking lights will begin to flash.
3. Press the arm/disarm or panic button once again and the siren will stop sounding and the lights will
stop flashing.
Note: The remote panic feature has an automatic shut off circuit. When the siren has sounded for 60
seconds, the panic circuit will turn itself off automatically.
Last Door Automatic Arming:
(If Programmed On)
Note: The automatic arming feature will not operate unless the alarm input triggers have been connected
directly to the existing or newly installed door jamb pins. Current sensing alone will not activate the
automatic arming circuit.
1. Disarm the alarm.
2. Set the ignition key to the on position, then turn it off.
3. Exit the vehicle. The siren will chirp 1 time when the door is closed.
4. The LED will begin to flash fast.
5. After 10, 20 or 30 seconds have passed (depending on remote feature programming), you will hear a
single chirp. The alarm is now armed.
6. The LED will flash at a regular rate indicating an armed condition.
Note: When the automatic arming feature is activated, so is the RF tamper re-arm circuit. Every time the
alarm is disarmed by remote, the RF tamper re-arm circuit will count for sixty seconds (LED will be
flashing fast) and the alarm will re-arm itself if no one has entered the vehicle.
Override Operation:
(Security System is Armed)
1. Enter the vehicle and the security systems will begin sounding at this point. Make sure that the
valet/override switch is in the “off” position
2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position.
3. Within 5 seconds of turning the ignition key “on”, place the valet switch to the “on” position.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode!
Note 1: If the valet switch is already in the “on” position when you turn “on” the ignition key, the override
function will be bypassed. Turn “off” the ignition key, place the valet switch in the “off” position and try again.
Note 2: If you fail to place the valet switch to the “on” position within 5 seconds of turning “on” the
ignition key, the override function will be locked out. Place the valet switch in the “off” position, turn “off”
the ignition key and try again.
Step 10: Speciality Feature and Optional Equipment Testing
