RS 350 M / RS 400 M / RS 500 M / RS 350 MW / RS 400 MW / RS 500 MW
EN
www.magmaweld.com
38
USER MANUAL | MANUAL DO UTILIZADOR | KULLANIM KILAVUZU
ANNEX 11 - FINE ADJUSTMENTS INSIDE THE WIRE FEEDING UNIT
You can make fine adjustments through panel which is above wire feeder.
1- Soft Start Switch:
While the switch is ON, the wire is fed at a slow speed until it touches to the work piece. Then, wire feeding goes on at the
adjusted speed. While the switch is OFF, wire feeding starts at the adjusted speed.
2- Free Wire Feeding Button:
The wire is fed as long as you push this button, but the gas ventile does not work. You can use this function for inserting
the wire to the torch.
3- Post-Gas Adjustment Trimmer:
In order to increase the post-gas time, rotate the trimmer clockwise with a slot screwdriver. In order to decrease
the post-gas time, rotate the trimmer counter-clockwise. Post-gas time can be adjusted in a range of 0-3 seconds.
4- Pre-Gas Adjustment Trimmer:
In order to increase the pre-gas time, rotate the trimmer clockwise with a slot screwdriver. In order to decrease
the pre-gas time, rotate the trimmer counter-clockwise. Pre-gas time can be adjusted in a range of 0-3 seconds.
5- Burn Back Adjustment Trimmer:
In order to increase the burn back time, rotate the trimmer clockwise with a slot screwdriver. In order to
decrease the burn back time, rotate the trimmer counter-clockwise. Burn back time can be adjusted in a range of 0-1 seconds.
Annex 11 - Fine Adjustments Inside The Wire Feeding Unit
