EN
www.magmaweld.com
RS 350 M / RS 400 M / RS 500 M / RS 350 MW / RS 400 MW / RS 500 MW
25
USER MANUAL | MANUAL DO UTILIZADOR | KULLANIM KILAVUZU
• Maintenance and repairs to the machine must be carried out by qualified personnel. Our company is not responsible
for accidents that may occur as a result of interventions by unauthorized persons.
• You can obtain the parts to be used during repair from our authorized service centers. Using original spare parts will
prolong the life of your machine and prevent performance losses.
• Always contact the manufacturer or an authorized service agent specified by the manufacturer.
• Any warranty attempt that is not authorized by the manufacturer during the warranty period will void all warranty
provisions.
• It is essential that you observe the applicable safety regulations during maintenance and repair work.
• Before carrying out any work on the machine for repair, disconnect the mains plug from the mains and wait 10
seconds for the capacitors to discharge.
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are encountered in your device.
Depending on the work load and contamination of your work environment, you can repeat the above processes more frequently.
• Do not remove the warning labels on the device. Replace the worn/torn labels with the new ones. Labels
can be obtained from the authorized service.
• Check your clamps and cambles. Pay attention to the connections and the durableness of the parts. Replace the
damaged/defective parts with the new ones. Do not ever make aditions to/repair the cables.
• Ensure adequate space for ventilation.
• Clean and tighten fasteners such as bolts and nuts.
• Check the lead of the electrode pliers and earth pliers.
• Open the side covers of the machine and clean with low pressure dry air. Do not apply compressed air to electronic
components at close range.
• Periodically replace the water in the tank of the water cooling unit with fresh, hard water and protect it against
freezing with antifreeze.
• The Wire Feeding Mechanism must be kept clean and the roller surfaces must not be lubricated.
• Always remove any deposits on the mechanism with dry air each time you replace a welding wire.
• The consumables on the torch should be cleaned regularly. It should be replaced if necessary. Make sure that these
materials are original products for long-term use.
4.1 Maintenance
Every 3 Months
Every 6 Months
4.2 Non-Periodic Maintenance
Never weld with the covers of the welder open.
Maintenance And Service
MAINTENANCE AND SERVICE
