28
www.magmaweld.com
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 350 - 450 - 550 M / MW PRO
EN
3.8 Starting and Ending the Welding Process
• Determine the Coarse Adjustment “, Fine Adjustment” and Wire Feed Speed from the welding parameters
table of your machine according to the diameter of the wire you will use, the type of gas you will use and the
thickness of the material to be welded, and set your machine to these settings.
• You can start welding after making sure that you comply with all safety rules and take the necessary
precautions.
• During welding, instantaneous welding voltage will be displayed in voltmeter and instantaneous welding
current will be displayed in ammeter.
• After you have finished working with the welding machine, allow the machine to cool down and turn the
on / off switch to “0”. Unplug the machine and close the gas cylinder.
Wire Diameter
Material Thickness
Coarse Adjustment Range
Fine Adjustment
Wire Feeding Speed
Current
Voltage
When not welding, leave the torch in such a way that it does not touch the workpiece, the welding
pliers, the hood of the machine and the trigger does not remain pressed.
3.9 Welding Parameters
RS 350 M - MW PRO
• The welding parameters were obtained by horizontal welding with solid wire in laboratory conditions.
Values may vary depending on the application and ambient conditions.
Operation
