EN
www.magmaweld.com
34
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
SMART SERIES / SMART SERİSİ
4.2 Troubleshooting
The following tables contain possible errors to be encountered and their solutions.
Machine is not operating
• Contact the authorized service
• Replace the contact nozzle
• Set the correct pressure wheel setting
• Change your voltage and wire speed settings
• Check the gas used and its setting. If the gas
cannot be adjusted, consult the authorized
service
• Contact the authorized service
• Problematic electrical connection in the machine
• Make sure the machine is connected to the
mains
• The power supply fuses, mains cable or plug
are problematic or damaged
• The pressure on the wire feed rollers is too light
• Check the power supply fuses, mains cable
and plug
• Set the correct pressure wheel setting
• The mains connections are not correct
• Wire feed rollers were not chosen to fit the
wire diameter
• Check whether the mains connections are
correct
• Select the appropriate wire feed roller
• Electronic card failure
• The pressure of the reels is not enough
• Contact nozzle size was selected incorrectly
or is damaged
• The welding parameters have not been
selected correctly
• The protecting gas flows too much or too
little
• Electronic card failure
• The on/off switch does not operate correctly
• Check the on/off switch
Wire feed motor failure
The wire feed motor is operating,
but the wire is not moving further
No good welding
Failure
Reason
Solution
• Make sure that the grounding clamps of the
machine is connected to the workpiece
• Make sure that the parameter and process
selection are correct
• Make sure that the tungsten tip is clean
• Make sure the welding torch is secure
• Contact the authorized service
• Contact the authorized service
• Check the pole that the electrode must be
connected to and the current value that
must be set on the machine
• Make sure that the cables are secure and
that the connection points are not worn
• Parameter and process selection are not correct
• Tungsten tip worn (TIG welding)
• The grounding clamps of the machine is
not connected to the workpiece
• Welding torch damaged (MIG, TIG welding)
• Electronic card failure
• Electronic card failure
• The welding parameters have not been
selected appropriately
• All parameters such as wire type, gas
type, etc. must be selected according to
your welding method
The value
0000
will be displayed on
the screen
• Electrode pole and amperage values are
incorrect (MMA welding)
• Cables and connection points are damaged
Fan is not operating
Unstable and/or non-adjustable
welding current
Unstable and/or non-adjustable
welding current
Maintenance and Service
Summary of Contents for ID 500 M PULSE SMART
Page 159: ......
