EN
www.magmaweld.com
26
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
SMART SERIES / SMART SERİSİ
METHOD:
It is the pnt welding to be mentioned in the mode. The welding continues for the specified welding period and ends at the end of the period.
No welding will be performed if as long as the defined void period. This period will continue as long as the trigger is not released. Welding Time: 0.2-9.9
and void time: It is between 0.0 and 9.9 seconds.
It should be preferred when the same welding seam and penetration are desired every time. The lengths of the welds made in Method mode will
be equal.
4 TRIGGER MODE:
When the torch trigger is pressed and released once, welding starts and there is no need to hold it pressed until the welding ends.
Pressing and releasing the trigger again will end the welding process.
Welding Start;
Welding Termination;
• Press and hold the torch trigger.
• Release the pressed torch trigger.
• Shielding gas flow starts as long as the pre-gas period.
• The wire feed motor will stop.
• At the end of the pre-gas period, the wire feed motor runs at a slow speed.
• The arc extinguishes after the set burn-back time.
• Welding current increases when the workpiece is reached.
• The process ends after the final gas period.
• Release the pressed torch trigger and the welding will continue.
PrG
: Initial Gas Time
I
: Welding Current
PoG
: Final Gas Time
Operation
Summary of Contents for ID 500 M PULSE SMART
Page 159: ......
