Magmaweld Compact Smart Series, User Manual

Page: 36 / 248

EN
36 COMPACT SMART SERIES
www.magmaweld.com USER MANUAL
Maintenance and Service
4.3 Error Codes
• There may be problems at different
points in the machine
• Contact the authorized service E01
E02
Communication
Error
• Visually inspect the fan for proper
operation. Please contact the
authorized service if it does not
operate
• Open the air ducts
• Wait for a while to allow the machine
to cool down. If the failure
disappears, try to run the machine at
lower amperage values
• Ensure that the machine is placed
in an area where it can work operate
comfortably
• The machine’s run time rate may have
been exceeded
• Fan may not be operating
• The air inlet and outlet ducts may
have been blocked
• The machine operating environment
can be extremely hot or lack of air
E03
E04
E05
E06
Thermal
Protection
• Contact the authorized service
• The machine may have been
overloaded
Overcurrent
Failure
Low mains
voltage
Temperature
Sensor
Reading Failure
High mains
voltage
• Contact the authorized service
• Check the mains connection cables
and voltage. Make sure that the
correct voltage input is provided. If
the mains voltage is normal, contact
the authorized service
• Check the mains connection cables
and voltage. Make sure that the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
• Contact the authorized service
• There may be problems at different
points in the machine
• Mains voltage may have decreased
• Mains voltage may have increased
• Temperature sensor may have failed
or there may be an electrical
connection problem
Error Code Error Cause Solution