Magma EB3600-AB, User Manual

Page: 49 / 143

Magma
EB3600-AB | Chapter 2 Hardware Installation 49
One solid Amber LED (D5) and three solid Green LEDs (D3, D8, and D7) are illuminated on the expansion
interface card. Upon connecting the power cable to an electrical outlet and applying power to the
expansion unit, the following LEDs are lit.
The LED on the top should turn AMBER when the power cord is connected to the device from the outlet.
When the front button On/Off switch is activated or pressed, the AC POWER LED should turn green.
Power ON Computer
To effectively use your Magma chassis as part of your computer system, ensure that all the proper
connections are made. Then power on your computer. This will enable your Magma chassis to turn ON.
Hardware Check
Once you have turned ON the Magma EB3600-AB and the host computer, the next thing to do is to check
the LED status on the hardware. Verify that the following LEDs on the expansion card, host card,
backplane, and front panel are illuminated.
 Interface Card and Expansion card operating normally should show up with four Solid Green LEDs (see
picture below). Reset is de-asserted, LED D5 is turned off.
 15 Solid Green LEDs on each backplane are illuminated (see picture below).
 Check LED "PORT 0 - D9" status, see if it is illuminated solid green or blinking fast.
 6 solid Green LEDs are lit on the front Panel Status LED indicator (see picture below).