Magma EB3600-10, User Manual

Page: 86 / 143

Magma
EB3600-AB | Chapter 4 General & Technical Information 86
If the alarm continues, you need to reset the system to default setting by pressing and holding the Alarm
Reset button (shown in the above diagram) until the LEDs blink. The color of the LEDs will turn orange. This
will enable the entire device to reboot to its default settings. You can only do this once the chassis is turned
off, but is still operating in standby power. So, ensure the power cable is connected between the chassis
and the AC outlet.
Each power supply module is labeled with a number that corresponds to their PSU-slot assignment on SNMP
web management. PSU#1 is located on the far left side of the expansion chassis and PSU#4 is on the far
right side of the expansion unit. The “Input Rating” (110-240) label is located on top of the power supply
module.