Magma
EB3600-AB | Chapter 2 Hardware Installation
22
Make sure to check the
dipswitch (SW4
) is set to proper configuration. The toggle switch should be
“ON=EXP” position as shown from the picture below. Apply the same configuration with the second
Expansion Interface card. By default the Expansion Interface card is set to “ON=EXP” and configured as
x16.
Next, check the SW3. This is another dipswitch that you need to check prior to installing the interface card.
The SW3 has two toggle switches and are set to x16 by default, see pictures below. User should not alter or
change the settings of SW3. If you encounter problems, for troubleshooting purposes only check SW3;
verify the dipswitches are set to x16.
When done verifying the SW4 and SW3 settings are correct, you can now plug in the primary Expansion
Interface card in the designated PCIe “SLOT 0-UPLINK, see pictures below.
Summary of Contents for EB3600-10
