Magma
EB3600-AB | Chapter 2 Hardware Installation
23
For the second Expansion Interface card, use the PCIe “SLOT 5-UPLINK”. Secure the edge connector
bracket with a retaining screw.
NOTE: The “Expansion” interface is the same card as the “Host” interface card. The only difference is the
setting on the SW4 switch. When SW4 is set to “ON=EXP”, the card becomes “Expansion interface card”,
and plugs into an expansion slot in the chassis. When it is set to “OFF-HOST, and plugs into a computer slot,
it is a “Host interface card”. See pictures below for the SW4 settings.
NOTE
The SW3 has two toggle switches and are set to x16 by default, see pictures below.
The Interface card has a mini built-in configurable toggle switch that can be set to x4, x8 and x16. The
expansion interface card default setting is x16. If the SW3 is not set correctly, your expansion system will not
link up properly to the host server / computer.
Summary of Contents for EB3600-10
