Installation
MKE Series Electric Griddle
L20-369 REV. 2 (05/12)
5
1.3. Installation
Setup
To Start uncrate appliance and locate installation accessories shipped with the appliance.
1.3.1. Counter Use With Legs
CAUTION
To prevent equipment damage, DO NOT tilt
your MagiKitch'n griddle on only two legs, or
on its sides.
(See Figure 2) A set of 4” (10 cm) legs is
shipped with the appliance (unless appliance
was specifically ordered without legs). A
threaded receptacle is located near each corner
of the underside of the base of the appliance, on
appliances 48" (122 cm) and wider there are
threaded receptacles in the front and rear center
of the base. Each leg has a similar mating
thread. Raise appliance sufficiently to allow legs
to be screwed tightly into receptacles. The
appliance can be leveled by adjusting the feet at
the bottom of the leg assembly. This can be
done by turning the foot in or out to lower or
raise each corner as needed.
NOTICE
4" (10 cm) Legs should not to be used with
the optional Equipment Stand.
1.3.2. Counter Use Without Legs
(See Figure 3) The appliance must be sealed to
the counter to comply with applicable sanitation
standards. A bead of silicone sealant,
approximately ½ inch (1.3 cm) wide, is to be
applied to the bottom of the unit approximately
¼” (0.6 cm) in from the front, back and side
edges. We suggest Dow Corning
, GE
or
Permatex
silicone ‘RTV’ adhesive sealant or
equivalent. (See NSF Basic Criteria C-2 for
details where applicable).
1.3.3. For Use On Optional
Equipment Stand
ATTENTION
Rear mounting brackets should be installed
to the Equipment Stand prior to placing
griddle on the stand.
CAUTION
Only two of the four supplied casters are
equipped with a locking feature. Install the
griddle so that the two locking casters are at
the front of the unit. The casters should be
LOCKED before the unit is placed into
operation.
CAUTION
The appliance must be level to perform
properly. Failure to level unit may result in
improper performance of the appliance.
Figure 3
Figure 2
Summary of Contents for MKE SERIES
Page 20: ...Accessories MKE Series Electric Griddle L20 369 REV 2 05 12 20 Figure 14 ...
Page 21: ...Accessories MKE Series Electric Griddle L20 369 REV 2 05 12 21 7 Notes Page ...
Page 22: ...Notes MKE Series Electric Griddle L20 369 REV 2 05 12 22 This Page Intentionally Left Blank ...
Page 23: ...Notes MKE Series Electric Griddle L20 369 REV 2 05 12 23 This Page Intentionally Left Blank ...
