12
CN3
11
No 5
(White) : (+)12V Siren Output
The Black wire at the siren is to be chassis grounded.
The siren volume can be reduced by cutting the volume wire attached to the
siren.
No 6
(Black) : (+)12V Trunk Output
If the vehicle is equipped with electrical trunk release, the trunk out is connected
to trigger the trunk solenoid.
No 1
(Blue) : Negative Starter-Kill output
Please use the pre-wired starter kill relay.
.... Anti Grinding ...
trunk
Solenoid
trunk Release Switch
CN2-6
87
Relay
85
86
30
87a
CN1-3
CN1-2
CN3-1
Cut
Start Motor
Key Holder
◀
Start Wire
OFF
ACC
ON
START
.... Anti Jacking ...
.... What is Noisy sensing ....
87
Relay
85
86
30
87a
CN1-3
CN1-3
CN3-1
Cut
Engine
Key Holder
Ignition Wire
▶
OFF
ACC
ON
START
No 2
(Yellow/Black) : Alternator sensing to monitor the engine running
This wire is to monitor engine running. Locate a small gauge wire from
the alternator. When tested with your meter, it should show you about 2V when
the key is on but the vehicle is not started.
When the vehicle is started using the key, the wire should read about 14V.
A. Noisy Sensing
When it is running, the engine generates sound and electrical noisy. Human
ears recognize the engine running by sound but Magicar can recognize by
electrical noisy. If you select the noisy setting, you do not have to connect the
alternator sensing wire. The factory default setting is Noisy Sensing
with High Sensitivity - Switch 1 Off and Switch 2 On.
(Starter-Kill)
(Ignition-Kill)
Summary of Contents for M9000
Page 4: ...6 M9000 Wiring Diagram 5...
