Magicar M9000, Installation Manual

Page: 12 / 13

22 21
Option Programming for Six Button(ONE WAY) Remotes
The procedures will be same as the 4 button remotes except
the use of the different buttons.
Programming
Programming Menu 1
Programming Menu 2
Option Selection
Factory Setting
Option Selection
Default Setting Selection
6 Button Remote
(Trunk+Start)-
(Trunk+Stop)-
(Stop)-
Lock
Unlock
(Start)-
4 Button Remote
(I+II)-
(I+IV)-
(IV)
( I )
( II )
( III )
Note :
1-2 Signal Light Flashing :
With this option, the signal will flash if
any door remains open while the vehicle is disarmed.
1-4 Anti-Grinding (Starter-Kill) :
The #1 wire of CN3 can be
programmed to send a signal to a relay to disconnects the starter wire of
the vehicle upon arming and upon remote-start to
prevents you from
recranking the starter on a remote - started vehicle.
Anti-Jacking (Ignition-Kill) :
The #1 wire of CN3 can be programmed
to send a signal to a relay to disconnect the ignition wire of the vehicle
upon anytime the vehicle is armed so that the vehicle cannot start or run
by a remote or a key. And the running of vehicle can be shut off by
remote’s panic command.
Programming Menu #1
Feature
Option 1
4 sec
Starter Delay for Diesel vehicle
Signal-light flash when door
remains open
Duration of Door Lock Output
Application of Pre-wired
Kill Relay
Ignition Unlock
Remote Start Reservation
Cranking Time
N/A
0.8 sec
Anti-Grinding
(Starter-Kill)
Anti-jacking
(Ignition-Kill)
ON
Automatic
Manual
Reservation is
not available
when any door
remains open
For Manual
only
Standard
S Min
S Max
OFF
10 sec
Activated
4 sec
(Factory Default)
Button
I
Button
II
Button
III
1-1
1-2
1-3
1-4
1-5
1-6
1-7
Programming Menu #2
Feature Option
2
Utilization Turbo
Hour Timer Start
Remote Start Engine
Running Time
AUX 1
AUX 2
Utilization
N/U
N/U
25 Minutes 45 Minutes 5 Minutes
60 sec Latch
60 sec
Latch
20 sec
0.5 sec
0.5 sec
15 Minutes
20 sec
(Factory Default)
Button
I
Button II Button
III
Button
IV
2-1
2-2
2-3
2-4
2-5
Note :
2-1, 2-2
If you want to utilize the Turbo mode and 24 Hr mode with your remote
control unit, you need to program the main module at the time of
installation.