20
19
2 .
Benz types of vehicles that have vacuum hose underneath the
ignition key box.
●
Follow the same steps of the above 1, except that you use button
I I I
instead
of button
I
.
The vehicle has a programming of automatic self-unlock when you turn off the engine
with a key. So, in this case you have to choose this Bentz type option programmed
locks doors upon remote-running end. The controller generates a negative relay output
for the relay that controls the vacuum hose.
3 .
Propane Gas Powered Vehicles
●
Follow the same steps of the above 1, except that you use button
IV
instead
of button
I
.
Step1 :
For Programming menu 1: Key on,engine off, then Press Buttons
(I+II)
for 2 seconds.
For Programming menu 2: Key on,engine off, then Press Buttons
(I+IV)
for 2 seconds. The car will chirp once indicating that you
are in programming mode.
Step2 :
Within a 4 seconds after pressing
(I+II)
o
r
(I+IV)
, press Button
IV
the number of times to go to the option number you want to
change.
You have to hear a chirp and see the parking light
flash each time when you press Button
IV
.
Step3 :
Wait a few seconds. You will hear a number of chirps and see a
number of parking light flashes corresponding to the option number
you want to change. If the number of chirps or flashes is not what
you want, go back to Step 1.
Option Programming for Four Button Remotes
Step4 :
Press Button
I
for the default factory settings and your car will
respond by one chirp and one flash. Press Button
II
for the
optional setting and your car will respond by two chirps and two
parking flashes.
■
If you hear a long chirp, you are going out of programming mode,
please go back to Step1.
■
If you want to change more options, go back to Step1.
Resetting
all
of Menu #1 or Menu #2 of Programming Options to
the factory default settings - if you are not sure about current
programming, change everything to the factory settings and start
again.
1. Resetting
all
of Menu #1 to the factory setting
Step1:
Press buttons
(I+II)
simultaneously for 2 seconds. This will be
confirmed by a siren chirp and a one-time flashing of the parking light.
Step2:
Press button
III
once. This will be confirmed by a car chirp and
parking light flash. Press button
III
again. You will be confirmed by a
car chirp and parking light flash again. Press button
III
third time.
You will be confirmed by a car chirp and parking light flash third time.
A few second later, your car will chirp and parking light flash three
times rapidly to confirm the resetting.
2. Resetting
all
of Menu #2 to the factory setting.
Follow the same steps above except that you press buttons
(I+
IV)
f
o
r
2
seconds at the Step 1 instead of buttons
(I+II)
.
Summary of Contents for M9000
Page 4: ...6 M9000 Wiring Diagram 5...
