14
13
No 3
(Red/Black) : Negative Trigger Door Open Sense
No 4
(Red) : Positive Trigger Door Open Sense
Please make sure you have found a correct door sensing wire that monitors all
doors.
+12V
CN3-3(-) Door Trigger
Dome Light
Door
Trigger SW
Door
Trigger SW
+12V
CN3-4(+) Door Trigger
Dome Light
B.
P
otential Problem with Noisy Sensing
Every vehicle generates different level of electrical noisy and a same vehicle
may generates different level of electrical noisy under different circumstances.
In some cases, therefore, it will be possible that Magicar thinks the engine is
running even though only heater fan is running.
C. Dip Switch Setting
●
●
Dip Switch #1
O N : For a vehicle that generates high level of electrical noisy.
This setting will reduce the sensitivity of Magicar.
OFF: For a vehicle that generates low level of electrical noisy when engine
is running
–
Factory Setting.
●
●
Dip Switch #2
O N : Noisy Sensing
–
Factory Setting
OFF: Alternator Sensing
D. Noisy Sensing LED
Please find the LED inside of the cover. The LED will come on when it senses
electrical noisy beyond preset level.
E. Verifying Noisy Sensing
If you are selecting Noisy Sensing, please verify if it works properly as follows
●
●
Step 1. Disconnect the siren wire.
●
●
Step 2. Maximize the heater fan volume. Also, turn on radio and wind shield
wipers
●
●
Step 3. Leave the switch #1 Off, and #2 On.
●
●
Step 4. Try remote starting.
a. The LED should stay off until the starter cranks and come on steady when
engine is running. Wait 2-3 minutes. If the LED stays on steady without any
blinking, you are done.
b. If the LED comes on before the engine is running, shut off the remote
starting, turn on he switch #1 and try remote starting again. The LED should
stay off until the starter cranks and come on steady for the next 2-3 minutes
when engine is running. However, if the LED comes on again before the engine
is running, or the LED does not come on at all, or the LED light blinks time to
time while the engine is running, elect Alternator Sensing. Noisy Sensing does
not work for this vehicle.
Note 1 :
For any diesel vehicles, we recommend you using Alternator
Sensing. In case you are using Noisy Sensing for a diesel vehicle, please
make sure you connect the glow plug wire.
Note 2 :
Noisy Sensing will not work for a vehicle that has an
alternator problem.
Summary of Contents for M9000
Page 4: ...6 M9000 Wiring Diagram 5...