Two-Way Remote User’s Guide
42
Two-Way Remote User’s Guide
41
Controlling Shock Sensor Sensitivity
To adjust the shock sensor sensitivity, locate the shock
sensor and adjust the dial on the sensor. The higher the
number on the dial, the higher the sensitivity of the
sensor.
Shock Sensor sensitivity can vary from vehicle to
vehicle for many reasons including where and how it
is mounted, and the size of the vehicle. Some after
install adjustment may be necessary to fine tune the
sensor.
Control of Siren Sound
In order to increase the volume of the siren, locate
the siren, (usually under the hood in the engine bay)
and cut the loop of black wire at the base of the siren.
Be careful not to cut the thicker black ground wire of
the siren.
If the remote has been lost or damaged, you can enter Valet Mode
using the ignition key of the vehicle. The following steps must be
completed within a limited amount of time, so please read
through the instructions before beginning.
1) Turn the key to the Ignition On position. When the ignition
is on, the lights in the instrument cluster will turn on. In most
vehicles this position is two clicks forward from the Off
position.
2)Move the key back one click to the Accessory On position.
The lights in the instrument cluster should turn off.
3) Steps 1 and 2 must be repeated for a total of three times within
three seconds. Once this has been done, the alarm will turn off
and valet mode will be active
Setting the Shock Sensor Sensitivity
The higher the numbers,
the more sensitive
Valet Mode can only be turned off through the remote
(Press buttons
I + III
for 0.5 sec. at the same time, the siren will chirp and the
parking lights will flash twice.)
Setup of Remote Options
To exit the remote programming menu, press buttons
II
+
III
for more than 2 sec.
The remote will automatically exit the programming menu if 15 sec. pass without a
button being pressed.
[ ]
Entering the Main Menu
The remote can be programmed
after pressing buttons
II III
for
more than 2 sec. at the same time.
Button Control Method
Menu End Method
The icon corresponding to the option you are changing will flash on the screen.
Note
Function(Menu)
Set-up of present time
Set-up of timer start
reservation time
hour control
hour control
hour control
minute control
minute control
minute control
change(basic :
cancellation)
change(basic :
Activation)
change(basic :
cancellation)
change
(basic : “ ”)
The change of
or
Set-up of alarm clock time
Set-up /cancellation of
alarm clock function
Set-up/cancellation RPS
Set-up/cancellation of
vibration mode
Change of the temperature unit
Button
I
II
III
IV
ba
ck
to
th
e
pr
ev
io
us
m
en
u
ba
ck
to
th
e
ne
xt
m
en
u
Entering Valet Mode Using a Key
Entering Valet Mode Using a Key
