Magellan NAV 6500, User Manual

Page: 69 / 114

Magellan NAV 6500/NAV 6510 61
Position coordinates on your receiver do not match the loca-
tion on your map.
1
Make sure that your receiver is set up to use
the same datum as your map. The map da-
tum is generally shown in the map legend. See
Map Datum under Navigation Setup for in-
structions on selecting the map datum in your
receiver.
Position fix fluctuates
1
Small changes in the position coordinates and
elevation are normal. They are caused by sev-
eral variables, including the geometric quality
of the fix and the effects of SA. Geometric
quality is a measurement of the probable ac-
curacy of a fix based on the position of the
satellites being used in relation to each other.
Unit does not recognize C-card installed
1
Make sure the C-card is mounted all the way
into the C-card slot so it is locked in place.
2
Check the C-card contacts to make sure they
are clean. If dirt is collected on the gold con-
tacts, use a soft dry cloth to wipe the dirt away.
If you are experiencing a problem that is not described above,
please contact Magellan Technical Support for assistance at
Tel.: (909) 394-5000 or Fax: (909) 394-7050. Technical Sup-
port engineers are available from 8 a.m. to 5 p.m. PST.
If none of the above fixes the problem, as a last resort, you
may attempt Total Memory Reset to clear the unit’s memory,
including waypoints, routes and GPS initialization informa-
tion. Total Memory Reset can be done under Aux-Memory
Reset or if the problem is such that you can’t access the Aux
functions follow this procedure.
With the unit off, press and hold any key and press the PWR
key simultaneously to turn on the unit. Highlight RAM us-
ing the
Cursor Key and press ENT . Press ENT again to clear
RAM. Turn off the unit.