11
10
MAGAZI LEVER PROTECTORS
1 | Scope of delivery
2 | General information
2.1 | Reading and keeping the instructions for use
These instructions for use apply exclusively to these magazi Lever Protectors.
They contain important information on installation, safety and warranty. You
should read the instructions carefully, in particular the safety instructions,
before installing or using the magazi Lever Protectors. Failure to follow these
instructions can cause damage to the vehicle and result in consequential
damage. Keep these instructions for future reference. If you pass the magazi
Lever Protectors on to a third party, you must hand over these instructions.
The instructions for use are based on the standards and regulations applicable
in the European Union and reflect the current state of technology. If abroad, also
observe country-specific guidelines and laws.
2.2 | Explanation of symbols
The following symbols and signal words are used in these instructions.
3 | Safety
3.1 | Intended use
magazi Lever Protectors are designed for tubular motorcycle handlebars with an
inside diameter of at least 14 mm. The ends of the handlebar must be open, i.e.
they must not be blocked by thread inserts or similar.
To ensure that you use these components correctly and safely on your
motorcycle, always adhere to the specifications in your vehicle operating
instructions and the stipulations of the vehicle manufacturer.
Only use the magazi Lever Protector as described in these instructions. Any
other use is considered improper use and may result in material damage. The
manufacturer or supplier accepts no liability for damage caused by improper or
incorrect use.
3.2 | Safety instructions
WARNING!
Danger for children and persons with reduced physical,
sensory or mental abilities (e.g. partially disabled persons,
WARNING!
This symbol/signal word indicates a hazard with a
medium risk level which, if not avoided, may result
in death or serious injury.
CAUTION!
This symbol/signal word indicates a hazard with
a low risk level which, if not avoided, may result in
minor or moderate injury.
IMPORTANT!
This signal word warns of possible material
damage.
This symbol indicates that the packaging and
product can be recycled.
Order no. 10018796 Brake lever protector
Order no. 10018797 Clutch lever protector
1
1x Lever protector, right (brake)
2
1x Lever protector, left (not shown)
(clutch)
3
1x Hex socket bolt
DIN 912 M6 x 65 A2
4
1x Clamping sleeve 14 mm Part 1
5
1x Clamping sleeve 14 mm Part 2
6
1x Clamping sleeve 18 mm
7
1x End piece: black, silver, red
8
2x Hex socket bolts
DIN 7991 M3 x 6
9
Instructions (not shown)
1
8
3
(2)
4
5
6
7
