PSS 3100 SE
22
01/2022
5.6
Cutting depth setting
The cutting depth can be set continuously in a range between 0 and 57 mm [0 to 2.24 in].
Use the following procedure to set the cutting
depth:
1.
Loosen the wing screw (5).
2.
Use the scale on the inside of the gear housing
to set the cutting depth.
➢
The beveled edge of the gear housing is
the depth indicator.
3.
Tighten the wing screw (5).
✓
The cutting depth is set.
Fig. 13: Setting the cutting depth
For separating cuts, always set the
cutting depth to approx. 2 ... 5 mm
[0.08 ... 0.2 in] more than the
material thickness you want to cut.
5.7
Setting the cutting length
A cutting length of up to 1300 mm [51.2 in] can be set with the guide rail. A continuously adjusted cutting length
of to 3100 mm [122 in] can be set with the guide rail extension.
Use the following procedure to adjust the cutting
length:
1.
Loosen the knurled screw on the stop slide 7.
2.
Move the stop slide 7 (with the knurled screw in
the groove of the guide rail) to a position that is
ca. 120 mm [4.72 in] further from the saw blade
than the desired cutting length.
3.
Tighten the knurled screw on the stop slide 7.
✓
The cutting length is set.
Fig. 14: Setting the cutting length
Caution
Risk of injury when the saw blade is not completely covered.
The saw blade will not return to its home position at the end of a cut if the
stop slide is not correctly set. Personal injuries may result as the saw blade
is not completely covered.
➢
Ensure the stop slide is correctly set.
