Madrigal Imaging MP-8, MP-9, Owner'S Manual

Page: 35 / 138

Step 14
➤
The final step is convergence. If the projector includes the ACON option,
press
to exit the guide and allow ACON to converge the system.
Otherwise, press to enter Guided Convergence.
Reminder: Remember that all of the adjustments above should be repeated for
other sources in the system.
2.10 Memory
Setup
This section explains how to set up projector memories to improve the per-
formance of the projector’s ASI and ASR features. If you are not familiar
with setup memories, read section 3,
Operation, prior to memory setup; in
particular, read section 3.4, Setup Memories, and the ASI with Save and Turn
ASR On/Off entries in section 3.7, Utility Features. If the projector’s setup
memories are properly set up, the projector will be easier to use and operate.
Note: Memory setup should be performed when the projector is in its final oper-
ating position. If the physical position of the projector changes, memory setup
must be repeated.
Here is a brief summary of the setup memory, ASR, and ASI discussions in
Section 3.
About Setup Memories ...
The projector has 75 setup memories for storing display settings of different
sources. Multiple setup memories are required since display settings usually
vary amongst sources. There are two types of setup memories: Input and
Recall. Both memory types store the same parameters. The only difference is
that Input memories store display settings for a particular physical input
(e.g., switcher 0, slot 1) while Recall memories can be used with any input.
At any one time, one setup memory is the current setup memory. The dis-
play settings in the current setup memory are used for the current display.
When a source is selected by entering its input number, the Input memory
for the selected input becomes the current setup memory*. If a Recall mem-
ory is selected, it becomes the current setup memory*. Display adjustments
are automatically saved in the setup memory which is current at the time of
adjustment (unless the setup memory is locked).
* Note: If the ASR feature (explained below) is turned on during setup memory
selection, the selected memory may not be the current setup memory.
To display the Recall memories stored in the projector, press .
Press to display the Input memories. (Unused setup memories are
not displayed).
4 UTIL
3 UTIL
1
CONV EXIT
4 CONV EXIT
INSTALLATION & SETUP
2.29