MADER HHGT-001B, Manual

Page: 79 / 101

Reverse Lever
Engages the wheels and tines into reverse.
Pulling the drive safety control lever (REVERSE) back toward the operator reverses tiller. Releasing the
lever stops the wheels and tines.
CAUTION!
Do not operate both “forward” and “reverse” drive safety control levers at the
same time.
This information is provided here only to introduce the controls. Do not start
the engine at this time. Please see the starting and operating instructions in this
manual. Please read this section and all operating and safety instructions before
starting your tiller.
• As a safety precaution, the drive safety control levers will not lock in the
forward or reverse position.
• As a safety precaution, the reverse drive safety control lever will not lock in
reverse.
• To stop the wheels and tines at any time, release the drive safety control levers
or release the reverse handle.
• Do not operate both the reverse and forward drive safety control levers at the
same time.
WARNING!
Engine should be off before adjusting any controls.
Extreme caution should be used when operating the tiller in the reverse direction.
ADJUSTMENTS
Wheel Lock Pins
Place the wheels in tilling position.
1. Remove the lock pin. Align the hole in the axle with the hole in the wheel
hub.
2. Insert the lock pin through the holes, fold the lock pin ring to secure the pin
to the axle.
3. Firmly lock the wheel and axle together before tilling.
4. Repeat for the other wheel.
79