02-18-2016
TE2 LED PCB
Mad Catz offers an LED PCB for VEWLIX layout Tournament Edition 2 FightSticks for Xbox One
and PS4/PS3 for lighting up translucent action buttons (sold separately) on your FightStick.
These will be forward compatible with the new TE2+ FightStick. For inserting an LED PCB,
please follow the below instructions.
Part 1: Main PCB
1.
After opening the FightStick, using a Philips screwdriver (not included), remove the two
Philips screws from the main PCB plastic cover.
2.
Gently lift up the plastic cover to reveal the main PCB.
3.
Insert one end of the LED PCB connector cable through the pass-through hole on the top
of the main PCB plastic cover and attach it to the connector port on the main PCB.
4.
Reverse instructions to re-attach the main PCB plastic cover.
Part 2: Buttons
1.
Using the flat head screwdriver tool, push inward on the small inside tabs of the button
harness quick disconnects to easily remove them from each of the eight action buttons.
2.
Replace buttons with translucent buttons if necessary (sold separately).
3.
Line up the four corner holes of the LED PCB with the four metal posts on the metal
button panel.
4.
Using the hex head screwdriver tool, screw the LED PCB into place using the included
four hex screws.
5.
Connect the other end of the LED PCB connector cable to the connector port on the LED
PCB.
6.
Using the button wires chart, re-attach the button harness quick disconnects to each of
the eight action buttons.
7.
LED PCB will light up when the FightStick is plugged in.
The Mad Catz LED PCB uses white LEDs, so it will work fine with any color translucent buttons.