Macurco
TM
DVP-1200 Manual
REV – 1.3.1
[34-8708-4770-7 ]
42
|
P a g e
Figure 4-38 –
Select CONFIGURATION and press ENTER. The current configuration for the selected horn/strobe will load and become editable
as shown in the images below.
Figure 4-39 –
The following options are available for horn/strobe configuration:
•
HS ON/OFF – Sets the selected Horn/Strobe to normally closed (ON) or normally open (OFF). Default value for this
setting is OFF.
•
DELAY – Sets a delay between when conditions to trigger the horn/strobe occur and when the horn/strobe turns on.
The time format is: [mm: ss]. The default delay time is 00:00. To set the delay for the selected horn/strobe, highlight
this sub-menu and press Enter.
•
MIN RUNTIME – Sets the minimum runtime once a horn/strobe is activated. The time format is: [mm: ss]. The default
minimum runtime is 00:00. To set the minimum runtime for the selected horn/strobe, highlight this sub-menu and
press Enter. A horn would not normally require a minimum on time, but this parameter allows a more versatile
configuration.
•
MODE – The horn/strobe MODE can be set to CONTINUOUS(DEFAULT) or INTERMITTENT.
•
ASSIGN TO ALARM/TRB – The horn/strobe can be assigned to activate during an ALARM, WARNING, or TROUBLE
condition (regardless of zone). The default setting is NOT ASSIGNED(DEFAULT).
NOTE: A horn/strobe assigned to ALARM/WARNING/TROUBLE will be dedicated to that function and will not be able to
be assigned to a zone.
•
SET – The user must select SET to save the changes. The changes will become active as soon as the user selects SET.
Summary of Contents for DVP-1200
Page 2: ......
Page 5: ...MacurcoTM DVP 1200 Manual REV 1 3 1 34 8708 4770 7 4 P a g e ...
Page 60: ......
Page 67: ......
