Macurco DVP-1200, Manual

Page: 31 / 68

Macurco TM DVP-1200 Manual
REV – 1.3.1 [34-8708-4770-7 ] 30 | P a g e
Figure 4-13 –
Refer to Figure 4-14 for sequence of display screen during deleting sensor from a zone. To remove a sensor from the zone,
select DELETE SENSOR and press ENTER. Enter the Modbus address of the sensor to remove from the zone and press ENTER.
The sensor will be deleted from the zone and the display will return to the ADD/DEL SENSORS menu. The bottom box of the
display will be updated to reflect this change.
Figure 4-14 –
To view the sensors assigned to the zone, select VIEW SENSOR and press ENTER. The middle box of the display will list the
addresses of the sensors assigned to the zone (Refer Figure X). Press ENTER or the LEFT arrow to return to the ADD/DEL
SENSORS menu.
Figure 4-15 –
4.6.2.2 RELAY(S)
Menu path: Main Menu-->CONFIGURE SYSTEM? -->MANUAL CONFIGURE? -->CONFIGURE ZONES? -->ADD/EDIT ZONES--
>RELAY(S): -->
To add relays to a zone or delete relays assigned from a zone, select “RELAY(S):” from the zone configuration menu and press
ENTER. Then, select ADD RELAY or DELETE RELAY as shown below. The bottom box of the display will show any relays assigned
to the zone and will get updated as you make changes.