SRM | V
-Clas
s High-P
er
formance P
ow
er
ed L
oudspeak
er S
eries
18
SRM | V-Class High-Performance Powered Loudspeaker Series
ZONE:
The zone mode setting is your optional
loudspeaker setup, ideal for when the speakers
are placed in different locations and allows for
separate main level controls.
SRM | V-Class loudspeakers in zone mode
setting will receive a mono-summed signal.
The following channels are available when the
SRM | V-Class loudspeakers are linked in zone mode:
• Ch. 1 Primary or Secondary
• Ch. 2 Primary or Secondary
• Bluetooth Primary or Secondary
• Primary or Secondary Main
As before, illuminating and selecting the left-facing
arrow returns you to the previous screen.
Configuration
This is where to select the Ch. 1 and 2 input settings,
front LED status and color, LCD brightness, lock access
to the settings, auto connect / link bluetooth and more.
This is similar to what you will see after first entering
the configuration screen. The current selection of the
top five features will be illuminated.
To change a setting, just rotate the speaker
control knob until the configuration you desire
to change is illuminated, then push to select it.
MODE
SUB
DELAY
BT
MIXER
CONFIG
CONFIGURATION
CH1 IN
ABOUT/RES...
FRONT LED
CH2 IN
LED COLOR
LCD SCREEN
BT SETTINGS...
LOCK...
LINE
MIC
HI
DIM
OFF
GRN
WH MUL
ON
OFF SIG
LINE
HI-Z
These are the choices from top to bottom:
Ch 1 in –
As mentioned a few pages back, the channel
1 input accepts both XLR and 1/4" inputs. In addition
to setting each channel’s gain knob to the correct
setting, be sure to set it here, as well. The selection
will illuminate green; line on the left, mic on the right.
Illuminating and selecting the left-facing arrow
returns you to the previous screen.
More information about the channel inputs
may be found on pages 10-11.
Ch 2 in –
In addition to the previously mentioned
channel 1 input, the channel 2 input allows
instruments to be connected directly into the 1/4" jack.
To connect an instrument directly without using a DI
Box, set channel 2’s gain knob to Hi-Z and change
the channel 2 input setting to Hi-Z. The Hi-Z text will
illuminate to indicate that Hi-Z is active. Next connect
the output from the instrument to the channel 2 1/4"
input. The input impedance is optimized for direct
connection and high-frequency fidelity is assured.
Guitars may sound dull and muddy without a DI
box or if Hi-Z is not engaged. When not set at Hi-Z,
the channel 2 1/4" input become a line input, as seen
below.
Illuminating and selecting the left-facing arrow
returns you to the previous screen.
More information about the channel inputs
may be found on pages 10-11.
CONFIGURATION
ABOUT/RES...
FRONT LED
CH2 IN
LED COLOR
LCD SCREEN
BT SETTINGS...
LOCK...
HI
DIM
OFF
GRN
WH MUL
ON
OFF SIG
LINE
HI-Z
CH1 IN
LINE
MIC
CONFIGURATION
ABOUT/RES...
FRONT LED
LED COLOR
LCD SCREEN
BT SETTINGS...
LOCK...
HI
DIM
OFF
GRN
WH MUL
ON
OFF SIG
CH1 IN
LINE
MIC
CH2 IN
LINE
HI-Z
